While power tools may be the most exciting component of your tool kit, basic hand tools can be just as attractive, and perhaps even more important. There isn’t always an effective solution for every problem you’ll encounter with every job you need to do in the shop, and keeping the low-tech basics on hand will make your home improvement projects easier and done faster. Here are six of my favorites to get you started.
Spring loaded nail set
It’s not exactly complicated, but it is Spring nails set It can come in really handy when you need to take care of nails that have popped at the moldings or to finish a project with some nails sticking out. You place the tip of the nail on top of the nail, pull it back at the end, and then let go. This efficient little thing will help keep your nails flush without a hammer, and it won’t mark the surface of the wood. You can get one for $14, and it fits in your pocket.
While the volume cat’s claw or crowbar It is a common shop tool, and it is good flat bar Essential when doing any type of woodworking. Flat tape can be used to correct errors when nailing moldings or wood parts and to separate pieces that have been glued, it will not mark your wood surface. To press down on the stripped screw, you can use the screw pull hole or the edge of the tool to leverage on it while loosening the screw. Using a flat bar to lift a heavier piece or wood while leveling the feet is also very convenient. At about $15 a set, flat bars can also help with pulling staples and peeling off linoleum.
If you have difficulty making your marks when making holes for hanging picture or shelf holders, a Deep hole mechanical pencil is just the thing. To trace your engraving pattern from piece to piece, this pencil will fit over the drilled hole and sink into a few inches of the material, making marking a breeze. If you have difficulty scoring peg holes or making holes in hardware, this is the tool for you. At $11 for a two-pack, these pocket-sized pencils are a great addition to your DIY kit.
All-in-one wiring tool
If you like to work on low voltage wiring projects, for example to repair lights or electronics, a Self-adjusting wire strippers and cutters is the right tool for you. Clean stripped wire and easy cutting make wire connections much quicker. Instead of switching between tools and gauges, you can use this combination pair of cutters for multiple sizes of wire, and save your hands from the struggle of wrestling with a dull tool. At around $20 a pair, this is a good bet for wiring projects. (As with any home repair involving electricity, be sure to only do electrical work that you are qualified to handle.)
magnets on a stick
When you’re working on a car or device, falling devices can be a real hindrance. modifiable , Telescoping, LED-illuminated pickup magnet It could be a lifesaver. If screws are sticking out under your air conditioner while you’re cleaning coils or if you’ve dropped your washers in your engine, a magnet on a stick comes in handy. magnets on lit The stick is better. About $8 will get you a tool with a pole and a light that can get into all kinds of hard to reach places.
equal spacing tool
For measuring and marking, there is a tool that can evenly divide your distances. To measure equidistant shelves, to mark lines for bracing or painting, or to ensure that seams are evenly spaced on a tapestry project, equal spacing tool He is the best friend. You can use the tool at any spacing up to the max, and it will divide your scores evenly without requiring you to do the math – just stretch it out and mark where the points fall. For about $13.50, it’ll be a handy addition the next time you’re hanging anything with more than one holder.
More from Lifehacker
#Simple #Tools #DIY